Nissan Patrol, Ford Maverick

1988-1997 of release

Repair and car operation



Nissan Patrol and Ford Maverik
+ Cars of the Nissan Patrol and Ford Maverick series
+ Diagnostics of malfunctions
+ Settings and routine maintenance
- Engine
   - Engine of 4.2 l
      Removal and engine installation
      Removal, dismantling, check of a condition and installation of assembly of yokes and bars of pushers
      Removal and installation of the inlet pipeline
      Removal and installation of a final collector
      Service of a head of cylinders
      Removal, check of a condition and service of components of a drive of the gas-distributing mechanism (chain and asterisks)
      Removal, check of a condition and installation of a camshaft and pushers
      Removal and installation of the pallet of a case and maslozabornik of the oil pump
      Service of the oil pump
      Replacement of epiploons of a cranked shaft
      Service of shatunno-piston assemblies and mirrors of cylinders
      Service of a cranked shaft and radical bearings
      Flywheel service / driving disk
      Removal and installation of support of the power unit
   + Engine of 3.0 l
+ Systems of cooling, heating and air conditioning
+ the Power supply system and production of the fulfilled gases
+ Systems of decrease in toxicity of the fulfilled gases
+ Systems of electric equipment of the engine
+ Transmission
+ Coupling
+ Brake system
+ Forward and back bridges, running gear and steering
+ Body
+ Onboard electric equipment





Removal and installation of support of the power unit

Forward support

Forward support

1 — a support (pillow)
2 — an arm
3 — bolts
4 — a nut

Removal

 PERFORMANCE ORDER

    To Poddomkratta the car also establish it on props. Prop up the engine a jack, for distribution of loading having laid between a head of a jack and the case pallet the wooden block.

At a poddomkrachivaniye of the engine be careful, - if to lift the engine too highly, will appear wires, driving cables, and also radiatorny and fuel hoses are loaded.

    Give a nut of fastening of a pillow of a support of the engine to an arm, remove a washer. Give bolts of fastening of a support of the engine to the car chassis. Slightly raise the engine and remove its support. In case of need the arm can be removed from the engine after an otdavaniye of fixing bolts.

The rubber support of the engine moistened with oil are subject to replacement. Thus it is necessary to define and eliminate the leak reason in order to avoid fast failure of a new support.

Installation

Installation is made upside-down.

 PERFORMANCE ORDER

    If the arm of a support acted in film from the engine, establish it on a place and tighten fixing bolts with effort of 77 ÷ 98 Nanometers. Do not tighten other fixture with final effort (77 ÷ 98 Nanometer) until all mass of the engine will not be transferred on its support.

Back support

Arrangement of back support of the power unit on a cross-section beam of the chassis

Removal

 PERFORMANCE ORDER

    To Poddomkratta the car also establish it on props. Prop up transmission by a jack, for distribution of loading having laid between a head of a jack and a transmission case the wooden block. Give nuts of fastening of a support to a cross-section beam. Give bolts of fastening of a support to transmission. Slightly raise transmission, watching to damaging electroconducting or the panel of a floor and remove a support from transmission.

The rubber support moistened with oil are subject to replacement. Thus it is necessary to define and eliminate the leak reason in order to avoid fast failure of a new support.

Installation

 PERFORMANCE ORDER

    Installation is made upside-down. Do not tighten fixture with final effort in 77 ÷ 98 Nanometers until all weight of the power unit will not be transferred on support.