Nissan Patrol, Ford Maverick

1988-1997 of release

Repair and car operation



Nissan Patrol and Ford Maverik
+ Cars of the Nissan Patrol and Ford Maverick series
+ Diagnostics of malfunctions
+ Settings and routine maintenance
+ Engine
+ Systems of cooling, heating and air conditioning
+ the Power supply system and production of the fulfilled gases
+ Systems of decrease in toxicity of the fulfilled gases
+ Systems of electric equipment of the engine
+ Transmission
+ Coupling
+ Brake system
- Forward and back bridges, running gear and steering
   + Peredny Bridge and suspension bracket
   + Forward suspension bracket of spring type
   + the Forward suspension bracket on screw springs
   + Back bridge and suspension bracket
   + Back suspension bracket of spring type
   + the Back suspension bracket on screw springs
   - Steering
      Primary checks
      The elementary checks and adjustments
      Removal and installation of a steering wheel
      Service of a steering column
      Removal and installation of the flexible coupling of a steering shaft
      Service of assembly of the steering mechanism
      Removal and installation of the steering pump
      Service of components of a steering drive
      Removal and installation of a steering damper
      Service of the pendular lever of cross-section steering draft
      Corners of installation of forward wheels (geometry of a forward suspension bracket and steering drive)
+ Body
+ Onboard electric equipment




Removal and installation of the steering pump

Complete check of a condition and major maintenance of the steering pump belong to the procedures which are beyond qualification of the average amateur mechanic. Remnabor cost, plus temporary expenses usually outweigh cost of the replaceable block which was in the use. In view of the aforesaid originators of this Management recommend to replace simply in default the pump it. For those who decided to try the forces in performance of repair of the steering pump authors give an explanatory illustration and the list of the main technical requirements (see size tables and adjustments at the end of the Management).

Components of the steering pump

1 — a cover
2 — the mesh filter
3 — a bolt
4 — a cuff
5 — the tank
6 — an arm
7 — the case
8 — laying
9 — pins
10 — a statorny ring
11 — a rotor
12 — blades
13 — a plate
14 — sealing rings
15 — a spring
16 — the socket
17 — шпуля
18 — an epiploon
19 — a shaft with the bearing
20 — a lock ring
21 — a pulley
22 — a nut
23 — a washer

Removal

 PERFORMANCE ORDER

  1. Disconnect a negative wire from the battery.
  2. Clear the pump outside, having removed from it dirt and greasing traces, in order to avoid their hit in hydraulic system in the course of pump dismantle.
  3. Weaken a fastening collar to the pump of the returnable line (appearance of the steering pump is shown on an accompanying illustration). For collecting spilled liquid keep under the union drain capacity.
1 — the tank
2 — the returnable line
3 — the pressure head line
4 — an arm
5 — a pulley
6 — the pump
  1. Give a hollow bolt of the shtutserny socket of fastening of the pressure head line and continue liquid plums in capacity. Fix the disconnected lines away from a working zone, having corked their open ends with a view of hit prevention in dirt system.
  2. Give an adjusting lock-nut, weaken fixing and adjusting bolts. Remove from the pump a driving belt.
  3. Turn out adjusting and fixing bolts of the pump and remove assembly of the last from the car.

Installation

Installation is made upside-down.

 PERFORMANCE ORDER

  1. Replace copper sealing washers and strongly tighten a hollow bolt of the shtutserny socket.
  2. Adjust effort of a tension of a driving belt.
  3. Pump over hydraulic system.







;