Nissan Patrol, Ford Maverick

1988-1997 of release

Repair and car operation



Nissan Patrol and Ford Maverik
+ Cars of the Nissan Patrol and Ford Maverick series
+ Diagnostics of malfunctions
+ Settings and routine maintenance
+ Engine
+ Systems of cooling, heating and air conditioning
+ the Power supply system and production of the fulfilled gases
+ Systems of decrease in toxicity of the fulfilled gases
+ Systems of electric equipment of the engine
+ Transmission
+ Coupling
+ Brake system
- Forward and back bridges, running gear and steering
   + Peredny Bridge and suspension bracket
   + Forward suspension bracket of spring type
   + the Forward suspension bracket on screw springs
   + Back bridge and suspension bracket
   + Back suspension bracket of spring type
   + the Back suspension bracket on screw springs
   - Steering
      Primary checks
      The elementary checks and adjustments
      Removal and installation of a steering wheel
      Service of a steering column
      Removal and installation of the flexible coupling of a steering shaft
      Service of assembly of the steering mechanism
      Removal and installation of the steering pump
      Service of components of a steering drive
      Removal and installation of a steering damper
      Service of the pendular lever of cross-section steering draft
      Corners of installation of forward wheels (geometry of a forward suspension bracket and steering drive)
+ Body
+ Onboard electric equipment




Removal and installation of the flexible coupling of a steering shaft

Removal

 PERFORMANCE ORDER

  1. Disconnect a negative wire from the battery.
  2. With quick-drying paint mark position of the flexible coupling in relation to a steering shaft and the steering mechanism.
  3. Give coupling bolts of the flexible coupling (see an accompanying illustration).
1 — bolts
2 — washers
3 — the coupling
  1. Open coupling cuts by means of a screw-driver with a wide sting.
  2. Shift the flexible coupling towards a steering wheel and remove it from the car.

Installation

 PERFORMANCE ORDER

  1. Before installation check a condition of a rubber element and шлицов the flexible coupling. In case of need make replacement.
  2. Achieve combination of the landing labels put in the course of dismantle, then tighten coupling bolts with effort of 39 ÷ 49 Nanometers.







;