Nissan Patrol, Ford Maverick

1988-1997 of release

Repair and car operation


Nissan Patrol and Ford Maverik
+ Cars of the Nissan Patrol and Ford Maverick series
+ Diagnostics of malfunctions
+ Settings and routine maintenance
+ Engine
+ Systems of cooling, heating and air conditioning
+ the Power supply system and production of the fulfilled gases
+ Systems of decrease in toxicity of the fulfilled gases
+ Systems of electric equipment of the engine
+ Transmission
+ Coupling
+ Brake system
- Forward and back bridges, running gear and steering
   + Peredny Bridge and suspension bracket
   + Forward suspension bracket of spring type
   + the Forward suspension bracket on screw springs
   + Back bridge and suspension bracket
   + Back suspension bracket of spring type
   + the Back suspension bracket on screw springs
   - Steering
      Primary checks
      The elementary checks and adjustments
      Removal and installation of a steering wheel
      Service of a steering column
      Removal and installation of the flexible coupling of a steering shaft
      Service of assembly of the steering mechanism
      Removal and installation of the steering pump
      Service of components of a steering drive
      Removal and installation of a steering damper
      Service of the pendular lever of cross-section steering draft
      Corners of installation of forward wheels (geometry of a forward suspension bracket and steering drive)
+ Body
+ Onboard electric equipment





Removal and installation of a steering wheel

For removal of the helmsman the special stripper is required.

Removal

 PERFORMANCE ORDER

    Disconnect a negative wire from the battery. On models with the central arrangement of the button of a horn carefully hook the button sideways by means of the tool with a flat sting and remove it from a wheel (see an accompanying illustration).
1 — a steering wheel
2 — the horn button
3 — a nut
4 — electroconducting
    On models with screw fastening of the button of a horn by means of a short screw-driver give fixing screws under a steering wheel. Disconnect from the button electroconducting. Mark the provision of a steering wheel on a shaft, then give a fixing nut. By means of a special stripper remove a wheel from a steering shaft.

Do not knock on an end face of a steering shaft as it is fraught with column damage.

Installation

Installation is made upside-down.

 PERFORMANCE ORDER

    Grease with universal greasing a returnable cam of the switch of indexes of turns from the back party of a steering wheel. Achieve combination of the adjusting labels put in the course of dismantle and plant a steering wheel on a shaft. Check serviceability of operation of the returnable mechanism of the switch of indexes of turns and tighten a nut of fastening of a steering wheel with effort of 29 ÷ 39 Nanometers.