Nissan Patrol, Ford Maverick

1988-1997 of release

Repair and car operation

Diagnostics of malfunctions of onboard electric equipment

Lighting devices

Functioning of lamps/lamps is broken

The lamp (ы) is faulty. Check, replace a defective lamp.

Electroconducting break takes place, or contact was disconnected. Check a lamp power-supply circuit, execute necessary repair.

The switch of the lighting device is faulty. Check, in case of need replace.

The safety lock failed, or its block is faulty.

The relay of the lighting device is faulty. Replace the relay.

Turn on the corresponding lighting devices and check a chain of their power supply by means of a lamp sampler (see accompanying illustrations). Begin with contact of the socle/boss of a lamp and move back to the power supply.

Brightness of a luminescence of lamps/lamps is broken

Grounding of lamps/lamps is incorrectly executed. Check reliability of fastening and a condition of plugs of grounding, both on the lamp case, and on a wire. Execute necessary repair.

Lamps not are established to that to nominal capacity/tension. Check, in case of need replace.

The reflector is polluted or damaged. Wipe a reflector, or replace it.

The lamp is faulty. Check by substitution obviously serviceable, in case of need replace.

The lens is polluted. Wipe, or replace.

The increased resistive resistance in a chain between the generator and the battery takes place, or terminal connections are faulty. Check, execute necessary repair.

Quality of electric connections in a chain between the battery and the engine or the generator is broken. Check a condition of a wire of grounding of the battery and the tire of grounding of the engine on the chassis.

The tension regulator is faulty. Replace the defective block.

More often decrease in intensity of a luminescence of lamps appears connected with pollution or oxidation of plugs of wires of grounding. Smooth out all terminal connections, check an electroconducting condition.

Indexes of turns

The lamp of the index does not function and is not audible breaker clicks

Fused a safety lock. Eliminate the reason of an overload and replace a safety lock.

The breaker is faulty. Replace. Location of the breaker is shown on an accompanying illustration.

The switch of indexes of turns is faulty. Replace.

Defect of electroconducting takes place. Check, execute necessary repair.

The lamp of the index does not function, but clicks of the breaker are clearly audible

The control lamp of the corresponding index fused. Check, replace.

Electroconducting of a control lamp is faulty. Check, execute necessary repair.

At replacement of lamps watch compliance of their electric parameters to technical requirements (see size tables and adjustments at the end of the Management).

The lamp of the index of turn burns low and blinks with the increased frequency

The breaker is faulty. Check, rumple the defective block.

The lamp of the forward or back index from the relevant party of the car fused. Check, replace a defective lamp.

At replacement of the breaker establish only firm blocks.

The alarm system does not function

The breaker failed. Check, replace the defective block.

The switch of the alarm system is faulty. Replace.