Nissan Patrol, Ford Maverick

1988-1997 of release

Repair and car operation


Nissan Patrol and Ford Maverik
+ Cars of the Nissan Patrol and Ford Maverick series
+ Diagnostics of malfunctions
+ Settings and routine maintenance
+ Engine
+ Systems of cooling, heating and air conditioning
+ the Power supply system and production of the fulfilled gases
+ Systems of decrease in toxicity of the fulfilled gases
+ Systems of electric equipment of the engine
+ Transmission
+ Coupling
+ Brake system
- Forward and back bridges, running gear and steering
   + Peredny Bridge and suspension bracket
   + Forward suspension bracket of spring type
   + the Forward suspension bracket on screw springs
   + Back bridge and suspension bracket
   + Back suspension bracket of spring type
   - Back suspension bracket on screw springs
      Service of shock-absorbers
      Removal and installation of screw springs of a back suspension bracket
      Removal and installation of a cross-section jet bar
      Removal and installation of longitudinal jet bars of a suspension bracket
      Removal and installation of the stabilizer of cross-section stability
      Removal and installation of assembly of the mechanism of shutdown of the back stabilizer of cross-section stability
   + Steering
+ Body
+ Onboard electric equipment





Removal and installation of assembly of the mechanism of shutdown of the back stabilizer of cross-section stability

Removal

Components of a drive of shutdown of the back stabilizer of cross-section stability

 

 PERFORMANCE ORDER

    To Poddomkratta a car back also establish it on the props got under a case of the bridge. Transfer the handle of management of shutdown of the stabilizer of cross-section stability to situation "Is included". Give a nut of the spherical hinge of the right rack of the stabilizer of cross-section stability and disconnect a rack from a bar. Disunite the electric socket of a control lamp. Disconnect a forward driving cable from back on a regulator. By means of flat-nose pliers remove a lock plate of a cable on an adjusting arm. Give coupling bolts of a cable and release bolts of fastening of assembly. Take assembly of shutdown of the stabilizer of cross-section stability from under the car. In case of need it is possible to remove a forward driving cable with the management handle, for what:
      Give coupling bolts of fastening of a cable to the car chassis. Give nuts of fastening of the handle of management to a partition. Turn out a bolt of fastening of the handle to the dashboard, remove the handle with a cable from the car.
    Check assembly of shutdown of the stabilizer of cross-section stability on existence of signs of damages. Pull a driving cable of assembly by a hand, checking serviceability of shutdown of a rack of the stabilizer. At a cable otpuskaniye the rack should be blocked strongly in assembly. In case of need make replacement.

Installation

Installation is made upside-down.

 PERFORMANCE ORDER

    Adjust length of a cable, achieving size of a free wheeling in 0.2 ÷ 0.7 mm. Make sure of reliability of fastening of the socket of a control lamp.