Nissan Patrol, Ford Maverick

1988-1997 of release

Repair and car operation


Nissan Patrol and Ford Maverik
+ Cars of the Nissan Patrol and Ford Maverick series
+ Diagnostics of malfunctions
+ Settings and routine maintenance
+ Engine
+ Systems of cooling, heating and air conditioning
+ the Power supply system and production of the fulfilled gases
+ Systems of decrease in toxicity of the fulfilled gases
+ Systems of electric equipment of the engine
+ Transmission
+ Coupling
+ Brake system
- Forward and back bridges, running gear and steering
   + Peredny Bridge and suspension bracket
   + Forward suspension bracket of spring type
   + the Forward suspension bracket on screw springs
   + Back bridge and suspension bracket
   + Back suspension bracket of spring type
   - Back suspension bracket on screw springs
      Service of shock-absorbers
      Removal and installation of screw springs of a back suspension bracket
      Removal and installation of a cross-section jet bar
      Removal and installation of longitudinal jet bars of a suspension bracket
      Removal and installation of the stabilizer of cross-section stability
      Removal and installation of assembly of the mechanism of shutdown of the back stabilizer of cross-section stability
   + Steering
+ Body
+ Onboard electric equipment





Removal and installation of the stabilizer of cross-section stability

Cнятие

 PERFORMANCE ORDER

    To Poddomkratta a car back also establish it on the props got under a case of the back bridge. Give nuts of fastening of racks of a bar to arms of the chassis and remove washers and rubber plugs (see an accompanying illustration).
1 — a nut
2 — a washer
3 — the rubber plug
4 — a rack
5 — a stabilizer bar
6 — a rubber pillow
7 — bolts
8 — an arm

On the models equipped with the mechanism of shutdown of the back stabilizer of cross-section stability the right rack is a detail of the mechanism of shutdown. Procedures of removal and installation of assembly of shutdown of the stabilizer of cross-section stability are described in the following Section (Steering).

    Give nuts of spherical hinges of racks of the stabilizer of cross-section stability and remove racks from the car. Give bolts of fastening of basic arms of a bar of the stabilizer of cross-section stability to a case of the back bridge. Remove arms from the car. Take a bar of the stabilizer of cross-section stability from under the car.

Installation

Installation is made upside-down.

 PERFORMANCE ORDER

    Check a condition and track correctness of landing of rubber pillows in arms. Tighten fixing bolts with effort of 25 ÷ 32 Nanometers. At the correct tightening of bolts the labels put with paint on a bar of the stabilizer of cross-section stability should act evenly from both parties. Check a condition of rubber plugs and spherical hinges of racks of the stabilizer of cross-section stability, track correctness of landing of components. Tighten nuts of spherical hinges with effort of 25 ÷ 32 Nanometers.