Nissan Patrol, Ford Maverick

1988-1997 of release

Repair and car operation

Nissan Patrol and Ford Maverik
+ Cars of the Nissan Patrol and Ford Maverick series
+ Diagnostics of malfunctions
+ Settings and routine maintenance
+ Engine
+ Systems of cooling, heating and air conditioning
+ the Power supply system and production of the fulfilled gases
+ Systems of decrease in toxicity of the fulfilled gases
+ Systems of electric equipment of the engine
+ Transmission
+ Coupling
+ Brake system
+ Forward and back bridges, running gear and steering
- Body
   Care of a body
   Removal of spots of a various origin from a vinyl upholstery and panels of furnish of salon
   Care of an upholstery and salon rugs
   Repair of insignificant damages of body panels
   Repair of considerable damages of a body
   Replacement of a windscreen and the fixed windowpanes
   Service of forward doors
   Service of back doors
   Removal and cowl installation
   Service of doors of a back of models Hardtop (Hardtop) and Versatile person (Station Wagon)
   Service of a door of a back of models of Utilitya (Van) (Utility)
   Removal and front grille installation
   Removal and installation of the central console
   Removal and installation of forward seats
   Removal and installation of a back seat
   Service of seat belts
   Removal and dashboard installation
+ Onboard electric equipment

Service of seat belts

General information

Lobbies and external back seats are equipped with seat belts of inertial type. Belts cover a chest and zone part of a trunk of passengers.

The central back seat is equipped with a zone belt with manual adjustment.

It is necessary to check a condition of all seat belts regularly. At any doubts in serviceability of a condition or functioning of assemblies it is necessary to replace them.

Condition check


    Check a material of belts on existence of attritions, istrepyvaniye, cuts, прожогов and other damages. The inertial belt should be extended completely, having winded from a drum and to examine on all its length. In case of detection of defects it is necessary to replace assembly of a belt. Make sure that belts are not overwound. Check reliability of a tightening of fixing nuts and bolts. Check serviceability of functioning of buckles of belts. In case of detection of any defects the corresponding belt should be replaced assembled. On belts of inertial type check serviceability of functioning of the returnable mechanism:
      Slowly extend a belt, checking smoothness of its course. Release a belt and make sure that it regularly comes back to a starting position. Sharply pull a belt, - the drum should be blocked. Moving on slow speed try to extend slowly a belt during sharp braking - the drum besides should be blocked.
    If the returnable mechanism does not function properly, replace defective assembly.