Nissan Patrol, Ford Maverick

1988-1997 of release

Repair and car operation


Nissan Patrol and Ford Maverik
+ Cars of the Nissan Patrol and Ford Maverick series
+ Diagnostics of malfunctions
+ Settings and routine maintenance
+ Engine
+ Systems of cooling, heating and air conditioning
+ the Power supply system and production of the fulfilled gases
+ Systems of decrease in toxicity of the fulfilled gases
+ Systems of electric equipment of the engine
+ Transmission
+ Coupling
+ Brake system
- Forward and back bridges, running gear and steering
   + Peredny Bridge and suspension bracket
   + Forward suspension bracket of spring type
   - Forward suspension bracket on screw springs
      Service of shock-absorbers
      Removal and installation of screw springs of a forward suspension bracket
      Removal and installation of a cross-section jet bar
      Removal and installation of longitudinal levers of a suspension bracket
      Removal and installation of the stabilizer of cross-section stability
      Adjustment of geometry of a forward suspension bracket and steering drive - the general information
   + Back bridge and suspension bracket
   + Back suspension bracket of spring type
   + the Back suspension bracket on screw springs
   + Steering
+ Body
+ Onboard electric equipment





Removal and installation of screw springs of a forward suspension bracket

For performance described below procedures the special tool for compression of screw springs is required.

Removal

Components of a screw spring of a forward suspension bracket
1 — bolts
2 — a cover
3 — a nut
4 — the limiter of a course of compression
5 — an insulator
6 — a spring

 PERFORMANCE ORDER

    To Poddomkratta a car front also establish it on the props got under a frame of the chassis. Give bolts of fastening of a cover of the limiter of a course of compression, uncover. Unscrew a nut of fastening of the limiter of a course of compression and leave the limiter operty in the bottom saddle of a spring. By means of the special tool compress a screw spring so that there was a possibility of its removal. Remove from the car a spring, the limiter of a course of compression and the top rubber insulator. Examine a spring on existence of cracks, signs of deformation and weakening of developed effort. Whenever possible compare length of a spring to the new. Check the limiter of a course of compression on existence of damages and signs of aging of a material.

Installation

Installation is made upside-down.

Track that the top saddle of a spring appeared in a located correct way, the limiter of a course of compression got in a spring.