Nissan Patrol and Ford Maverik
+ Cars of the Nissan Patrol and Ford Maverick series
+ Diagnostics of malfunctions
+ Settings and routine maintenance
+ Engine
+ Systems of cooling, heating and air conditioning
- Power supply system and production of the fulfilled gases
- Power supply system of carburetor engines (3.0 l and early 4.2 l)
Removal and installation of an air purifier and pyleotdelitel of preliminary cleaning
Removal and installation of the fuel filter
Carburetor service
Service of the fuel pump
Service of the electromagnetic valve of return of fuel - only models of 3.0 l
Service of a cable of a drive of a butterfly valve
Service of a cable of a manual drive of a butterfly valve
Service of a fuel tank
+ Systems of injection of fuel (EFI) and engine management - models of 4.2 l of release after 1992.
+ System of production of the fulfilled gases
+ Systems of decrease in toxicity of the fulfilled gases
+ Systems of electric equipment of the engine
+ Transmission
+ Coupling
+ Brake system
+ Forward and back bridges, running gear and steering
+ Body
+ Onboard electric equipment
|
Service of a fuel tank
|
|
Described below procedure the Versatile person and Hardtop are applicable to models with a body. For other types of bodies of work are carried out similarly with necessary amendments on design features of a body. |
Removal and installation
Removal
|
|
Disconnect a negative wire from the battery.
In a luggage compartment give fixing screws and remove fastened hooks.
Give fixing screws and remove furnish of fastening of a rug from shutters of a door of a back.
Combine a rug forward and give screws of fastening of a cover of access. Uncover.
Disconnect and закупорьте fuel hoses. Disunite the electric socket.
|
| |
The block of the sensor of fuel consumption, and on models of 3.0 l also a gasoline pump, now can be taken from a fuel tank for performance of necessary repair after a fixture otdavaniye. The sensor of fuel consumption of models of 4.2 l taken from a fuel tank is shown on an accompanying illustration. |
|
To Poddomkratta a car back also establish it on props.
|
|
Carefully turn out a drain stopper of a fuel tank (see an accompanying illustration) and merge fuel in the pure canister. Screw a stopper on a place and strongly tighten it.
|
Working through an aperture of an arch of the right back wheel, give bolts of fastening of the filter of a jellied mouth to the tank case, remove the screen.
Weaken collars of fastening of a jellied mouth and a tube of branch of fuel evaporations (the corresponding components of a tank of models of 4.2 l are shown on an accompanying illustration).
Give fixing bolts and lower down the fuel tank filter.
Give bolts of fastening of a tank to the chassis and carefully take a tank from under the car. Before tank extraction once again make sure that the jellied mouth and a tube of branch of fuel evaporations are disconnected.
|
|
Installation
Installation is made upside-down.
|
|
Track, that all hoses were in good repair and are connected correctly to the unions.
At installation of a tank track correctness of connection of tubes of a jellied mouth to it and branch of fuel evaporations.
Fill in in a tank pure fuel and check it on leaks.
|
|
|
|