Nissan Patrol and Ford Maverik
- Cars of the Nissan Patrol and Ford Maverick series
Identification numbers of the car
Acquisition of spare parts
Technology of service, tool and workplace equipment
Automobile himikaliya, oils and greasings
Poddomkrachivaniye of the car and change of wheels
Engine start from an auxiliary source
Towage
+ Diagnostics of malfunctions
+ Settings and routine maintenance
+ Engine
+ Systems of cooling, heating and air conditioning
+ the Power supply system and production of the fulfilled gases
+ Systems of decrease in toxicity of the fulfilled gases
+ Systems of electric equipment of the engine
+ Transmission
+ Coupling
+ Brake system
+ Forward and back bridges, running gear and steering
+ Body
+ Onboard electric equipment
|
Poddomkrachivaniye of the car and change of wheels Enclosed in a set to the car the jack is intended only for a car pripodnimaniye for the purpose of change of wheels in road conditions, or for its installation on props.
|
|
Park the car away from the highway on an equal horizontal platform, it is desirable with a firm covering.
Turn on the alarm system.
Firmly cock the parking brake. Transfer manual transmission to the provision of a reverse gear, automatic - in the situation "R".
Track, that all passengers left salon and prop up to wedges a wheel located on a diagonals concerning a subject to removal.
Take a jack and tools.
Remove from an arm or подвеса a spare wheel.
Put on a ballonny key a wheel nut so that its handle took place horizontally and it appeared is directed to the left concerning a wheel disk. Having pressed for the handle end, give a nut 1/2 ÷ 1 turn counter-clockwise. Operating similarly, weaken the remained nuts of fastening of a wheel.
Get a jack under the corresponding domkratny point under the forward or back bridge (see accompanying illustrations) and slightly raise the car.
|
Point of an institution of a jack under the forward bridge of the car |
|
Point of an institution of a jack under the back bridge of the car |
Make sure of correctness of placement and stability of a jack.
Lift the car so that the wheel subject to change came off the earth. The size of a separation of a wheel should provide sufficient working space for installation.
|
|
|
|
At all do not perform any works under the car, fixed in the lifted situation only by means of a jack! Do not take out a jack out of limits of the site noted by paint under its installation. |
|
|
Unscrew fixing nuts and remove a wheel from the car.
For simplification of installation before dressing a wheel, achieve combination of openings in a disk with nave hairpins. In case of need use the handle of a ballonny key as the lever for temporary fixing of a wheel in the lifted situation.
Holding a wheel on a nave, freely acquire a nut of its fastening, having pressed their landing cone to opening edges in a disk.
Ballonnym a key tighten nuts in a diagonal order.
Lower the car on the earth and take a jack.
|
|
Ballonnym a key finally tighten nuts of fastening of a wheel in a diagonal order in some stages (see an accompanying illustration).
|
Clean wedges from under diagonalno located wheel and clean the removed wheel, a jack and the tool on the regular places.
At the first possibility make repair of the removed wheel in a shinomontazhny workshop and check effort of a tightening of wheel nuts a dinamometrichesky key.
|
|
|
|
If the car is completed with wheels with cast disks, repeatedly tighten nuts of fastening of a wheel through 1 000 km of run. |
|
|